22 - 24 October 2019
Perfect cleaning of machined turbocharger housings
High cleaning quality and short cycle times in combination with low space and energy requirements, and this for the lowest possible investment. In cycle times under 60 seconds the system removes dirt and clamping chips from the workpieces in several zones and finally dries the parts. Maximum 600 microns particle size after cleaning was the challenging quality specification.
Maximum processing time and machine flexibility
On a specially designed cleaning pallet, the turbochargers are very quickly fed through the machine via chain drive. In the individual process zones, the cleaning platforms are decoupled from the chain and are individually movable. This allows optimal alignment process to spraying technique. Thanks to the very quick part transport, the available processing time in each zone can be better exploited. This construction also allows flexibility for different type turbocharger, which can be cleaned in the washing machine. The spraying technique is divided into three areas. Two of them work with low pressure and a chamber is equipped with a high-pressure cleaning system. This one works with pressures below 200 bar and removes reliably all clamping chips from the workpieces.
Energy efficiency all around
Each process zone has been constructed so that the water quantity and the pressure level have been very reduced to the real requirements. Much attention was paid also to the entire air flow inside and outside the machine.
With a reduced quantity of water, divided into two baths, you can expect manageable energy costs in daily operation. Bag filters perform the filtration and the bath heating is electric. In the drying zone, optimized air quantity exhaust technique and a vacuum chamber are used. In the drying zone, optimized air quantity exhaust technique and a vacuum chamber are used.
NC water jet centre based on a dual-chamber system for the alternating processing of camshafts. In this particular case, processing is carried out using cutting ...
A sophisticated machine concept allows high pressure deburring in very short cycle time and reduced costs. You can see the machine RoboJet on show at parts2clean.
Large horizontal processing centre with high-speed swivel table and bulkhead. The swivel table is fitted with two rotary plates (B-axes), separated by means of a ...
In two fields in particular crankshafts / camshafts and turbine housing / turbine blades, we have developed and built innovative solutions concepts to meet the exacting ...
Subcontracting cleaning and deburring of your parts: a precision service provided by Piller
For small quantities, tests for bridging delivery periods or low volume ...
In the last few years, the requirements for parts cleanliness have become increasingly tough and they will continue to become more demanding in the
future. Today, ...
The vacuum dryer is also available as an standalone component. Equipped with state-of-the-art vacuum pumps, it gives consistent optimal drying results for your components.
Our washing stations are developed based on the separate medium supply concept. This minimises media carry-over. Each process stage is comprised
of a chamber with ...
Highly innovative high-pressure jet cleaning with water, cutting oil and cooling lubricant
Patented, unique high-pressure water jet techniques
For all levels of ...